Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 5 of 5
  1. #1
    3D Printer Noob
    Join Date
    Jul 2018
    Posts
    3
    Post Thanks / Like

    CR10 display control knob intermiten

    Having a problem with the control knob on the display, some times it takes 4-5 pushes before it takes the command.
    Has anyone had this problem and if so can you recommend a fix?

    Thanks
    David

  2. #2
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    3,084
    Post Thanks / Like
    Try removing the knob and adding a small portion of plastic or paper on the hole, then reapply the knob.

  3. #3
    3D Printer Noob
    Join Date
    Jul 2018
    Posts
    3
    Post Thanks / Like
    Thanks I'll give it a try after work today.

    - - - - - - - - - -

    Quick update. I pulled the knob off last night and used it without any problems, I ran to prints with no issues. I'll look for a knob that fits tighter.
    Thanks bolsoncerrado I think you pointed me in the right direction.

  4. #4
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    3,084
    Post Thanks / Like
    I use this one on my Prusas....
    https://www.thingiverse.com/thing:2792829

  5. #5
    3D Printer Noob
    Join Date
    Jul 2018
    Posts
    3
    Post Thanks / Like
    I'll down load it tonight and give it a try.

    Again thanks for you help.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •