Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3
  1. #1
    3D Printer Noob
    Join Date
    Dec 2018
    Posts
    1
    Post Thanks / Like

    Question Bed heater problem

    I bought my printer in October and it has developed a problem with the heated bed. The printer won't start printing because the bed won't heat. Then when it does print the bed will stop heating during the print. I was printing tethered to a computer running Matter Control and the print failed and matter control gave me a hardware error message for the heater. At one point I touched the heated bed control cable connector where it connects to the control box and it was hot. Is this just an issue with the wiring harness for the bed heater or a problem with the main control board?

    I suspect it is an issue with the wiring harness, I noticed when it was printing but the bed was cold, when I touched the wiring harness it made a hum and the temperature started to rise again. It should be under warranty right?

  2. #2
    Super Moderator
    Join Date
    Nov 2016
    Posts
    3,411
    Post Thanks / Like
    Your explanation is consistent with your analysis. You may have an issue in the connection itself or you may have a broken wire within the insulation. If you have the ability to do some point-to-point testing of the two main heater wires, you can probably find the intermittent connection pretty quick. Motion is often the result of heater plate wiring issues, be it the thermister or the feed wires.

  3. #3
    3D Printer Noob
    Join Date
    Jan 2019
    Posts
    8
    Post Thanks / Like
    I had the same issue. I prurcahse a replacement bed pre wired from Creality for $45.

 

 

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •