Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 5 of 5
  1. #1
    Super Moderator
    Join Date
    Nov 2016
    Posts
    1,839
    Post Thanks / Like

    Any integration experience with TMC2100?

    TMC2100 is a cheap little stepper filter that should quiet 3D printers that don't have this capability installed on their motherboard.

    Anyone care to weigh in on how the TMC2100 would be wired into our common stepper configurations?

    This might just qualify as a longevity upgrade.

    TNX

  2. #2
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    3,186
    Post Thanks / Like
    I think they follow the same PIN orientation as many, just match GND pins and that should be it....

  3. #3
    Super Moderator
    Join Date
    Nov 2016
    Posts
    1,839
    Post Thanks / Like
    Just a pass-through device?

  4. #4
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    3,186
    Post Thanks / Like
    No, its a driver, like A8 or DRV8825.

  5. #5
    Super Moderator
    Join Date
    Nov 2016
    Posts
    1,839
    Post Thanks / Like
    Aha... but there is a pass-through device... I just happened upon this.



    Fast forward to 5:30

    I don't think our Cube3 suffers from this but for those seeing unexplained patterns on other printers, you might consider these.

    I consider these electronic spike snubbers. Also notice that this is appropriate for extrusion, not necessarily motion.

    And it will help solve back EMF. That alone can be a useful function for all stepper motors.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •