Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3
  1. #1
    Regular 3D Printer
    Join Date
    Dec 2014
    Location
    St. Petersburg, Russia
    Posts
    73
    Post Thanks / Like

    Stepper Motor Specs

    Does anyone have the specs for all the 4 motors? Are they the same? If you didn't assemble the printer yet or opened the extruder, please post the photos of the motor backs.

    With the assembled printer you can easily check only the Y motor.

    I'm interested in the extruder motor especially because of the issues described in this thread.

    If the motors are the same, I can probably swap 2 of them to see if it fixes my extruder issue (just too lazy to disassemble it again right now).

    Y motor: Act Motor 1.2A 1.8 degrees 17HS5412L22P1-X3

    motor.jpg

    Also, is there any way to adjust the microsteps? There is no 3-DIP switch on the PCB, is it done via firmware?

    Last edited by CrazyCoder; 01-06-2015 at 01:37 AM.

  2. #2
    Expert 3D Printer
    Join Date
    Dec 2014
    Posts
    305
    Post Thanks / Like
    The extruder motor is smaller.
    I swapped it with the X and Y motor plugs to test it, and it worked fine.
    Also the other motors connected to the extruder motor plug also worked well according to what command I sent it to do.

  3. #3
    Regular 3D Printer
    Join Date
    Dec 2014
    Location
    St. Petersburg, Russia
    Posts
    73
    Post Thanks / Like
    Disassembled it again, here are the specs for the extruder motor:




    Other photos with part dimensions.


    1.8 degrees 1.7A 17HS4417P1-X18

 

 

Similar Threads

  1. Replacement PFTE Source, Specs?
    By clayton in forum Rapide Lite 3D Printers
    Replies: 8
    Last Post: 11-04-2019, 10:08 AM
  2. Z axis stepper motor dead after upgrading
    By Gort in forum Rapide Lite 3D Printers
    Replies: 6
    Last Post: 08-18-2016, 08:36 PM
  3. Stepper Driver Adjustment Video and Configuration Discussion
    By Justin Keller in forum Rapide Lite 3D Printers
    Replies: 21
    Last Post: 12-18-2015, 08:09 AM
  4. My extruder motor is gone?
    By ievolve in forum Rapide Lite 3D Printers
    Replies: 8
    Last Post: 02-16-2015, 08:46 AM
  5. Optimal stepper driver current settings?
    By cshaw85 in forum Rapide Lite 3D Printers
    Replies: 2
    Last Post: 01-18-2015, 09:07 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •