The ReCube Wand Help Thread.

[TommyDee]

I have not tried to change a chip to wood because the software would have to recognize the chip and CubePro doesn't. Does the chip read back what you told it to write?

edit; my bad - it does support wood... Let me see why this doesn't work.

- - - - - - - - - -

Use command 10,5,25;[enter] for wood.

[bmwcrazyman]

I tried resetting the chip 100% then doing the change to wood and it worked! I don't know why that would make a difference but it now reads perfect on my pro

[TommyDee]

Some things can get confused. Confirm max amount and make sure it matches CubePro. I've made some bad updates to the chip but they always recovered.

[RicciEU]

Hi All,

Thanks for a great thread TommyDee, could not have done this without this thread.

So after some head scratching I have figured out how to load the firmware onto the Nano . . . I think. I'll know tomorrow when I try to reload a chip.

One note the batch file named the flash file as : ReCubelight.ino.hex , just change the file name to the same as the file in Tomuro's file which is : ReCube.ino.hex and it seem to work after that.

Can anyone tell me what the : ReCube.ino.with_bootloader.hex file is for?

Cheers

RS

[TommyDee]

I have not found use for the bootloader version.

[RicciEU]

Hello All,

Can some one please help, I have built my wand circuit and am able to reload my chip to 98% through Arduino IDE serial monitor with the command 8,99;<enter>.

But I would now like to change the colour to black and the and the amount. Would the command 5,2;8,99;<enter> achieve that? Both are ABS. I understand that it is not possible to change material type with the lite version but is it possible to change the colour?

Cheers,
RS

[TommyDee]

Color is also a Pro feature.

[RicciEU]

Cheers TommyDee, Would it really matter if I used an ABS orange chip with ABS black filament?

[TommyDee]

None whatsoever. You can even slice it using neon green ABS in CubePrint 4.03

[RicciEU]

None whatsoever. You can even slice it using neon green ABS in CubePrint 4.03

Cheers TommyDee