Hack 3D Cube Pro Trio with FW 2.01

[TommyDee]

Not that I am aware of. Second best bet is to make one; http://www.print3dforum.com/showthre...muro-s-Circuit

I have not heard from William for a while. I hope all is well with him.

[cezari]

Thanks for the fast reply Tommy and for the detailed instryctions on building the circuit.
I can easily manage the hardware in a couple of days. What I am not so clear is what kind of script / programm should be loaded on the Arduino Nano board so that it does the resetting of the Cartrige chip when it is connected to it? I have not seen anything on the thread that spells out the Arduino programming that is involved on the resetting cycle (ReCube v. light / pro)
Can you elaborate?

[TommyDee]

The thread gets into the loading of the firmware onto the Arduino. There is an installer. ReCube is basically a stand-alone loader where you need to set a couple of switches in the command line.

[cezari]

Can you send me a link to the loading firmware section? I either missed the setp or I am looking at a different thread all together - sorry I'm new in the forum and I am getting crosseyed following the different sources
http://www.haxtom.com/?p=78 also talks about a ReCube Light vs Pro version (pay option). Any links to that dawnload?

[TommyDee]

http://www.print3dforum.com/showthre...d-Help-Thread?

This was linked in there somewhere.

The Pro version is a paid version. You would have to get in touch with Tomuro. I have no idea on his current activity with regard to Recube.

[cezari]

Thank you bro - appreciate the detailed response and information. I'll try to follow the last thread you provided above.