Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Z gap problem

  1. #1
    3D Printer Noob
    Join Date
    Aug 2017
    Posts
    6
    Post Thanks / Like

    Z gap problem

    Hi All,

    My cube 3D printer suddenly have problem in z gap. the Z high is already wrong. When I do Auto Gap, the machine not stop when move up.
    And continue move up. I think the z high information inside machine is wrong.


    Is it any method can correct it?


    Please help.

  2. #2
    Super Moderator
    Join Date
    Nov 2016
    Posts
    2,218
    Post Thanks / Like
    The initial Z-gap is set in the Maintenance menu under Calibrate. This is a default that the system uses. You can either follow the instructions and try to get a good Z-value here or just give it 3mm or so just so it never crashes. This setting is what is used for auto-level, which tends to fail better than 1/2 the time for a proper setting. I always recommend a manual setting regardless of what the Cube does by default.

    When you calibrate the default Z-elevation, be sure to hit the unmarked button where it says Cal2 to complete the function.

    If the machine continues to act strange, reinstall the firmware in case a bit got lost.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •