Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2
  1. #1
    3D Printer Noob
    Join Date
    Jun 2019
    Posts
    2
    Post Thanks / Like

    Question Cr10s s5 TH3D firmware upload issue!!

    I'm trying to upload TH3D firmware to my Cr10s s5 (the model with filament sensor) to install a Bondtech BMG clone and thermal runaway protection. It complies fine using a windows 10 laptop and the Arduino provide by TH3D , but i can't get it to upload - I've updated usb driver and uninstalled my original Arduino installation, but still I can not get it to work - Any hints, tips, or sage advice? This is the error I am getting.(unrelated links removed by admin)
    Last edited by TommyDee; 06-15-2019 at 05:38 AM.

  2. #2
    Super Moderator
    Join Date
    Nov 2016
    Posts
    2,069
    Post Thanks / Like
    Are you running into insufficient memory errors? This was reported earlier as the newer higher end CR10's have their memory capacity increased.
    I'll see if I can link you up with the thread if you can't find it here on the forum.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •