Thanks Thanks:  0
Likes Likes:  1
Dislikes Dislikes:  0
Results 1 to 2 of 2
  1. #1
    3D Printer Noob
    Join Date
    Jun 2019
    Post Thanks / Like

    Changes to a RapideLite 200 3D printer

    he following was completed mid february 2015. I did not publish it at that time but here are some things I changed to the RapideLite 200 printer:

    What changed:

    1. Move the Z-axis stop to the max position.
    2. Terminate the end stop lines properly and add debouncing.
    3. Add an auto Z-length and levelling probe
    4. Install Repetier firmware with a better new auto levelling routine
    5. Replace the extruder and carrier Mobdro

      • Create a printed carrier for a hot-end and Z-probe
      • Mount a bowden driven E3D-v6 hot end
      • Add a force-sensing bowden driver cold end

    Last edited by Konickmickson; 06-29-2019 at 09:01 PM.

  2. Likes bolsoncerrado liked this post
  3. #2
    Super Moderator
    Join Date
    Nov 2016
    Post Thanks / Like
    Welcome to the forum, Konickmickson.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts