Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2
  1. #1
    3D Printer Noob
    Join Date
    Jun 2019
    Posts
    2
    Post Thanks / Like

    CR-10 printing stepped/sawtooth corners on XYZ Cube (and more!)!!

    This just started occurring yesterday when I was spitting out a cube for a new filament. It's been happening on 3 different filaments from different manufacturers. It's weirdly consistent, skipping every few layers. Hey, at least there's no ghosting.youjizz pornhub tubegalore



    Staring at this images makes me start to wonder about layer heights & the z-screw...
    Last edited by kenyangomes; 06-29-2019 at 09:41 PM.

  2. #2
    Super Moderator
    Join Date
    Nov 2016
    Posts
    2,297
    Post Thanks / Like
    This normally indicates a problem in the hotend. Something akin to a clog.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •