Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3
  1. #1
    Super Moderator
    Join Date
    Nov 2016
    Posts
    2,347
    Post Thanks / Like

    eBay deal on Nylon advanced material for CubePro.

    Just a heads up for a decent deal on about a kilo of Nylon @ <$30.

    https://www.ebay.com/itm/Cube-2nd-Ge...e/113710247535

    Not my auction!

    And yes, I have one coming my way ;]

    I had to double check... indeed the Nylon is compatible with stock CubePro nozzles (0.35mm).
    Nylon is also compatible with Infinity Rinse support material.

    Should have ordered 2
    Last edited by TommyDee; 08-01-2019 at 07:47 PM.

  2. #2
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    3,226
    Post Thanks / Like
    What temp requirements have this nylon? I hear its the worst filament to fight against humidity so old filament could be a serious issue...

  3. #3
    Super Moderator
    Join Date
    Nov 2016
    Posts
    2,347
    Post Thanks / Like
    I'm not sure but I can run a test file and see. I believe it is 265 which means it should run in the Cube3 too.

    Nylon is the pits in most regards. It definitely absorbs water like nobodies business.
    However, I don't anything abut nylon aging like PLA does. Even ABS is pretty good about time.
    Since these are a second generation material offering, I don't suspect it is too old.
    I'll let you know when it gets here in a week.

    - - - - - - - - - -

    My bad; Nyl on Cubepro runs at 280C. It also forces sidewalks [because it curls like a bear!]. And it works with Infinity Rinse.

    - - - - - - - - - -

    Oh, and don't forget these new cartridges should be clear. That is a bonus.

    - - - - - - - - - -

    And the black nylon came in today. Lot code says Oct 8, 2015. Vacuum pack is intact and better than most of this vintage.

    Considering I have a project in mind for this, maybe I should order a few more

    Not ready to pop the seal though.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •