Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2
  1. #1
    3D Printer Noob
    Join Date
    Aug 2019
    Post Thanks / Like

    Help me mend the bend, warping with PETG suggestions welcome!

    I have been printing PETG with no issues for some time on my CRS10-Pro, I have used various filament producers and whilst there is always a little fettling when you change filament on the whole all prints well.

  2. #2
    Super Moderator
    Join Date
    Nov 2016
    Post Thanks / Like
    Welcome to the forum, Soney9.

    Learned a new word today.... fettling

    I have seen good results from PETG and bad. The best results are from a clear PETG and the worst was black. Could just be variation between manufacturers.

    Lokbuild and a brim help a lot!



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts