Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 6 of 6
  1. #1
    3D Printer Noob
    Join Date
    Oct 2019
    Posts
    10
    Post Thanks / Like

    New temp sensor print jet.

    Hi my name is Frank. Iím from Denmark. I have a cube pro and I need to get a new temp sensor. The one leg broke on the print jet
    Is it possible to use another making or do I need to use an original....?
    Kindly
    Frank

  2. #2
    Super Moderator
    Join Date
    Nov 2016
    Posts
    2,347
    Post Thanks / Like
    Are you talking about the wire going into the gray ceramic at the end of the nozzle or the little bulb stuffed in between the fins?

    Recently someone made it clear that the little bulb in the fins is a thermal fuse which mean you could just connect the two wires.
    I haven't confirmed this but makes sense. The thermister should be buried in the gray epoxy with the heater coil.

  3. #3
    3D Printer Noob
    Join Date
    Oct 2019
    Posts
    10
    Post Thanks / Like
    Yes it is.. didnít think about that. Sounds reasonable that itís just a fuse. Must try and connect without it...😀
    I can let you know how it vent..

  4. #4
    Super Moderator
    Join Date
    Nov 2016
    Posts
    2,347
    Post Thanks / Like
    You might be able to bypass this fuse at the connector of the consolidation PCB.

  5. #5
    3D Printer Noob
    Join Date
    Oct 2019
    Posts
    10
    Post Thanks / Like
    I took away the thermal fuse and soldered the wires together.. it works like a charm.. itís been printing for 10 minutes already..👍

  6. #6
    Super Moderator
    Join Date
    Nov 2016
    Posts
    2,347
    Post Thanks / Like
    Happy Printing Frankthy Thanks for report back.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •