Anyhow, since i returned to the office from the day before, seeing the print halted and touching the bed and realizing it was hot, freaked me out so I hit emergency stop on Repetier and accidentally quit it! Problem now was to figure out how to "resume" the print (at this point i didnt even know if i would be able to!).

After checking the printed part, and given I "reset" the software (no more XYZ accurate positions!), the only thing left was to manually find out where it was. SO we need to find out the three coordinates AND an average idea of which layer could this be... How to us the FF skin generator to get more benefit?
Anyhow, since i returned to the office from the day before, seeing the print halted and touching the bed and realizing it was hot, freaked me out so I hit emergency stop on Repetier and accidentally quit it! Problem now was to figure out how to "resume" the print (at this point i didnt even know if i would be able to!).

After checking the printed part, and given I "reset" the software (no more XYZ accurate positions!), the only thing left was to manually find out where it was. SO we need to find out the three coordinates AND an average idea of which layer could this be...