Thanks Thanks:  2
Likes Likes:  1
Dislikes Dislikes:  0
Results 1 to 10 of 21

Threaded View

  1. #21
    3D Printer Noob
    Join Date
    Sep 2021
    Posts
    1
    Post Thanks / Like
    If you're operating off a laptop through something like Pronterface, I think that shows the last line of Gcode that happened before it crashed, so you can use the exact same G-code, and just resume from where it stopped.


    I haven't any experience with this though. It's worth noting that if you're printing with a heated bed, the print can pop off the bed as it cools off, completely ruining your chances of resuming it. Otherwise, if you're printing ABS, the last printed layer could have cooled so much that prints are likely to be weak at that point.


    There's is also sometimes a slight deformation/gap where it resumes due to some plastic oozing out of the nozzle as it heats up (which forms a blob if you don't wipe it off, and a gap if you do). When resuming, I try to preheat the nozzle to temperature, expel some filament, and quickly resume before it oozes too much.

 

 

Similar Threads

  1. 3D Printer Materials Guide
    By bolsoncerrado in forum 3D Print Materials & Filaments
    Replies: 1
    Last Post: 09-14-2021, 11:46 PM
  2. Print Quality Troubleshooting Guide
    By bolsoncerrado in forum Latest News
    Replies: 1
    Last Post: 05-19-2018, 01:05 PM
  3. [GUIDE] LCD Installation
    By Rex in forum Rapide Lite 3D Printers
    Replies: 24
    Last Post: 09-20-2015, 04:40 PM
  4. Print Troubleshooting Pictorial Guide
    By bolsoncerrado in forum Latest News
    Replies: 0
    Last Post: 01-25-2015, 09:16 PM
  5. newbie with an iMac - startup guide anyone?
    By jcamen in forum Rapide Lite 3D Printers
    Replies: 27
    Last Post: 12-24-2014, 12:33 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •