Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3
  1. #1
    3D Printer Noob
    Join Date
    Dec 2017
    Posts
    2
    Post Thanks / Like

    Cr-10s Auto leveling gone ?

    Wondering if I did anything wrong after upgrading firmware to 1.1.6 ...since I upgraded I lost leveling option on printer control. Any idea if I can get it back

  2. #2
    Super Moderator
    Join Date
    Nov 2016
    Posts
    2,931
    Post Thanks / Like
    Welcome to the forum dawgslife. I don't have a CR10s but I do a lot of gleaning. I remember something about insufficient memory for code on the internal processor. However, that might just warn that the code is too large. Could it be that leveling is remarked out in the F/W you are installing?

  3. #3
    3D Printer Noob
    Join Date
    Feb 2020
    Location
    suffolk
    Posts
    2
    Post Thanks / Like
    Have you been on you tube as here there is a chap who walks you through setting up Marlin, Unless you have Installed Marlin 2. If that's the case there is another person who can help with those setting.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •