Hello Everyone --

I have more than one CR-10s where I installed the Th3D ABL Pro. For that it is necessary to re-flash the CR-10 with their version of Marlin. I also have a Raspberry Pi with Octoprint to control it.

If you have a similar setting, you'll know that the screen of the CR-10s will work if you have the Raspberry connected on connected to the printer, even if the printer is off.

I just realized that one of my printers' screen is not being powered by the printer, but by the raspberry... besides that... everything works...

so, the question is... is there a way to fix that? where everything in the printer works but the screen doesn't light up?

Thanks
Alejandro