I AM NOT AFFILIATED WITH Simplify3d IN ANY WAY! i AM JUST A USER OF THERE SOFTWARE!

I have 3 CubePro just getting into putting them to use.
2 x Trio
1 x Duo

All have v2.0 Factory firmware

I am using Simplify3d 4.1.2 just purchased, installed, Logged in, and setup through the configuration assistant.

All are set up with ABS

Printing is excellent at medium quality! Dimensional stability is incredible!
It is just so unfortunate that the 3DS slicer was so bad at infill and support structures.

Now I just need Simplify3d to help me out with setting up the CubePro Duo for NYLON and PVA!

I will be posting PICs of printed parts.

I WOULD LIKE OTHERS TO SHARE THERE Simplify3d EXPERIENCES HERE

Keep an eye on my profile, as I will be posting pics of machines that I have used, from home built RERAP to Professional grade.
Hopefully I can get all this in wile thing are on lock down. You know normally the life rat race.