CUBENSTEIN open conversion

[cucurutxo]

Yes, original PSU is 24V, but hotend is not connected straight to the PSU.

I'm using the original cube pro hotend and it works @19V. I connected it to the 24V PSU with a MOSFET and a stepdown set @19V.

[TexAM]

I got all the bits required, duet 2 and e3d hotend.
Looking at the wiring at the moment and not sure how to go around it, thinking about criming wires to allow them to fit on the duet... but dont know if thats the best.

Any advice, suggestions and/or wiring guidance will be very much appreciated

[Natasha789]

Hello guys,

- - - - - - - - - -

Hello guys,

- - - - - - - - - -

Hello guys,

- - - - - - - - - -

HELLO EVERYONE,

CUBENSTEIN's open conversion is a groundbreaking innovation that holds immense potential. By allowing seamless data exchange and interoperability across platforms, it fosters collaboration and accelerates progress. This technology heralds a new era of accessibility and standardization, empowering users to harness the full benefits of open systems.