Hii everyone,
I have an issue regarding heatbed. I have an ac heater of heatbed and i want to control it through ramps PID as well as turn it on zero cross detection. For this i have made the schematics, does it work fine? If you have any best idea to do so then please suggest.
Thanks and Regards,
Shubham.
Thanks: 1
Likes: 0
Dislikes: 0
Results 1 to 3 of 3
Thread: Heated Bed Issue
-
05-29-2020, 10:43 AM #13D Printer Noob
- Join Date
- May 2020
- Posts
- 2
- Post Thanks / Like
Heated Bed Issue
-
05-29-2020, 05:41 PM #2Super Moderator
- Join Date
- Nov 2016
- Posts
- 3,498
- Post Thanks / Like
This is very nice Kernel_07. Welcome to the forum. This is way over my head but I hope someone will review your proposal.
-
05-30-2020, 09:16 AM #33D Printer Noob
- Join Date
- May 2020
- Posts
- 2
- Post Thanks / Like
Hello Sir,
If you have any doubt regarding any part of the schematics, please let me know freely. I will try my best to elaborate my approach to resolve this issue.
Thanks for your valuable reply.
Thanks and regards,
Shubham.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
TommyDee thanked for this post
Reply With Quote