OctoPi 0.11.0 available!

[bolsoncerrado]

As of 13th Feb 2015.
>> Click!

[SAO]

Hi Bolson,

there also 0.12.0 since the 16th.

I have just received my Pi2 and print with Octoprint.
It's fabulous, you upload the gcode from your computer, and you have a total control of the printer from your computer, as well as with your android phone.
You can see the job with the camera...

Top !

[bolsoncerrado]

Yeah that was on the previous version too (I think?) unless they've made the interface "responsive" to the screen it is opened with?

Where's 0.12.0 then?

[SAO]

sorry, Bolson, I made a mistake
I have downloaded it from nightly directory, perhaps it is not a stable version.

It is a very big change for me, because before that, I only printed with sd card.
I had stop issues with USB.
And to have a control like that is new and impressive.

[bolsoncerrado]

SO in the end Ethan was right and SOME of you did have issues with the OS/software and not the board!

[SAO]

I tryed on few computer and few OS (win7, win8.1, Mac Os 10.6) but it always stopped after few minutes, it was for that I only printed by USB.
For me Octopi is a revolution.
Sorry for my enthousiasm

[bolsoncerrado]

Yeah octopi kicks ass, as long as it connects to your board haha

[SAO]

Hello Bolson,

I had few issues when i wanted to print via USB so I only printed by Sd card.
So I bought a Pi in order to try a different way to print and it worked until today.

Now It stops in the first layer as before as if it has com problems.

I have change nothing.

Do you think it could be the board? as you

[bolsoncerrado]

Hmmmm... not "as me" bc mine never actually "connected" even if the device was seen by the computer...

So besides "stopping on the first layer", can you resume? you need to reset and start over? can you try enabling octoprint logs and post some results here?

cheers.

[SAO]

It crach the pi, i can't move the mouse.
So i cancel the print with the remote computer.
And I must unplug the pi

When i try to activate log about serial connection, i can check the button to activate it, but the save button doesn't work when i click on this option

I try to reinstal octoprint and I will tell you