Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2
  1. #1
    3D Printer Noob
    Join Date
    Aug 2020
    Posts
    1
    Post Thanks / Like

    CR10s Pro different nozzle height with each print

    Hello all,

    Lately my CR10s Pro has been starting off each print at a different height. I am using the stock probe on a creality glass bed. I don't adjust the Z offset at all (example I always leave it at -.3) but it seems that sometimes it will print high or way low. To trouble shoot this I stop the print and drop it down say -.3 but it will still be way high or low. There seems to be almost no correlation to the height it starts printing compared to what I enter into the LCD. I of course have tried leveling my bed, lowering the sensor a bit closer to the glass and re adjusting the sensor's sensitivity with the little screw on top. One thing I noticed is that compared to my friend's identical printer his screw seems much more responsive in terms of when the light comes on. I turn the screw just until the light turns on but then it will take 4-5 turns the other way to turn it off. I know these sensors can be affected by all sorts of factors but it seems like this has really gotten worse lately. Do you think maybe my sensor is somehow going bad?

  2. #2
    Super Moderator
    Join Date
    Nov 2016
    Posts
    3,348
    Post Thanks / Like
    Welcome to the forum. I am not familiar enough to comment so I will leave that to others.

 

 

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •