Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 1 of 1
  1. #1
    3D Printer Noob
    Join Date
    Aug 2020
    Posts
    1
    Post Thanks / Like

    Different thermistor for CR-10

    I've had numerous problems with the thermistor - over-tightening, under-tightening, etc
    On spec I saw a threaded thermistor that looked like it might fit in the screw hole (my hotend is micro-swiss but I think the vanilla has the same hole). Fortunately it fits perfectly and seems to work fine - I'm printing as I type and it looks good.
    Here's a link to the one I bought. You'll obviously have to butcher the wiring a bit - I've been quite neat and used shrink-wrap over the soldered joins...

    PS - I'll report back after doing a few prints to see if it was money well spent :-)

    https://www.amazon.co.uk/gp/product/...?ie=UTF8&psc=1

    REPORT BACK - Don't do it. After a couple of prints it began to behave like the standard glass ball - jumping to 360 and shutting down - normally a sign of overtightening. Even after I slackened the screw it was inconsistent and failed another couple of times, at which point I went back to the fiddly but slightly more reliable glass bead .....
    Ho Hum.......
    Last edited by UKBikerman; 08-24-2020 at 06:28 AM.

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •