Good evening,


Well IÂ’m scrambling with ideamaker, in fact compared to simplify 3D, the settings are really very careful, which is not unpleasant.
I adjusted my extrusion and my flow with little onions, while browsing the doc and the forum I was able to pick some tips for filling.


My big concern is the angles that are swollen while they were sharp with simplify 3D... I tried to play on jerk, cabotage, wiping, printed the outer shell first to limit the pressure of the inner shells etc but obviously nothing does it...
I wonder if my brand new nozzle wouldnÂ’t already have a problem... yet it seems quality...


IÂ’m out of ideas...