Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2
  1. #1
    3D Printer Noob
    Join Date
    Jul 2021
    Location
    US
    Posts
    1
    Post Thanks / Like

    Over-Extrusion of filament while printing?

    Hello, I just got my substitution hot end today and have introduced it and begun printing. I've gone through the pre-flight test and Z-Axis alignment. All great. I aligned the extruder, discovered it was under-expelling only a tad, so changed the means per mm appropriately.


    Notwithstanding, I have an issue. At the point when I start a print, and the spout preheats, I end up with overabundance fiber snaking out. At the point when it goes to track down the 9 adjustment focuses I frequently get the "Debris on nozzle" blunder and need to reset and clean it. This happens more often than not right now. In the event that I raise the Z-pivot up and just hit 'Preheat', I get an unending line of fiber overflowing out. While looking for the solution, I have already covered the following guides:

    https://www.simplify3d.com/support/p...ent-extrusion/
    https://content.instructables.com/OR...YLJMV0TH4G.pdf
    https://www.printerwire.com/common-3...ting-problems/
    https://s3-us-west-2.amazonaws.com/o...Guide-Anet.pdf


    But the issue stand still in front of me. Any ideas? Is my temp excessively high? Could my extruder be excessively free?

  2. #2
    3D Printer Noob
    Join Date
    Aug 2021
    Posts
    1
    Post Thanks / Like
    Quote Originally Posted by luellacooke View Post
    Hello, I just got my substitution hot end today and have introduced it and begun printing. I've gone through the pre-flight test and Z-Axis alignment. All great. I aligned the extruder, discovered it was under-expelling only a tad, so changed the means per mm appropriately.


    Notwithstanding, I have an issue. At the point when I start a print, and the spout preheats, I end up with overabundance fiber snaking out. At the point when it goes to track down the 9 adjustment focuses I frequently get the "Debris on nozzle" blunder and need to reset and clean it. This happens more often than not right now. In the event that I raise the Z-pivot up and just hit 'Preheat', I get an unending line of fiber overflowing out. While looking for the solution, I have already covered the following guides:

    https://www.simplify3d.com/support/p...ent-extrusion/
    https://content.instructables.com/OR...YLJMV0TH4G.pdf
    https://www.printerwire.com/common-3...ting-problems/
    https://s3-us-west-2.amazonaws.com/o...Guide-Anet.pdf


    But the issue stand still in front of me. Any ideas? Is my temp excessively high? Could my extruder be excessively free?
    Well I' m here for the same.. someone can help?

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •