Hello fellow Cubers,

I recently got a brand new in the box Cube3 that had never printed before. The filament is very brittle, but printable. I used the "Auto Gap" feature and assumed it would fine, and it was for the first few test prints. Anyways, I neglected to check the gap before a print and found the nozzle had made numerous small indentations in the center of the bed! I am not planning on using it bare for long, as I intend on taking @TommyDee's suggestion of using the LokBuild surface. But in the mean time, Is there a way I can fill these divots to provide a flat sub straight again?

Cheers,

T3x