Thanks Thanks:  9
Likes Likes:  8
Dislikes Dislikes:  0
Page 7 of 7 FirstFirst ... 567
Results 61 to 62 of 62
  1. #61
    Super Moderator
    Join Date
    Nov 2016
    Post Thanks / Like
    That is wonderful news, once again no less. Now do some printing and tell us what you think.

  2. #62
    3D Printer Noob
    Join Date
    Mar 2021
    Post Thanks / Like

    Started to experiment and took off the front of the spool and hooked up some Matterhackers black PETG.


    Printing was very smooth, no warping or layer adhesion issues. Filament seemed to print fine even at a high temperature. Unable to figure out what temperature its printing at.


    Finished print was great! Right is original Ekocycle black filament and left is Matterhackers black PETG. I even think the Matterhackers black PETG came out better than the Ekocycle filament. Even after these prints the spool still reads 66%, so the modded firmware is working like it should.

    I think this will be good enough to get back onto the floor and have students start printing again. If I have time in the future I'd like to get some mods going and make it a much more easy to use printer.

    Thanks for your help everyone, I hope to continue contributing what I can to this community.


  3. Thanks TommyDee thanked for this post


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts