You Tube Video's for the Rapide Lite 3D Printer

[Justin Keller]

Please post all related you tube videos in this thread.

[Justin Keller]

[Justin Keller]

[ievolve]

Its fun to watch someone go through the same process that I did. I'm not sure how you will choose to cut the calibration video. For me it was literally a few days of WTF. But I am finally pretty dialed in and pretty happy. Definitely not for the faint of heart though.

[Justin Keller]

Good to know. Yeah, I'm still in the process of gathering all the info. I hope to have it out soon as I'm eager to start printing. I designed a Christmas ornament and hope to get it printed in time but we'll see. Are you using Cura?

[ievolve]

Dont bother with Cura. Go with Repetier Host. I'm not sure how anyone in their right mind would recommend Cura over Repetier.

[Justin Keller]

Okay, I'll check it out. Thanks

[synthius]

Cura is all I've been using. I had problems connecting with repetier but connected with cura first try.

[Justin Keller]

Intresting, I'm new to each of them so I'll check them both out. I downloaded Cura a few days ago and it installed an Arduino driver. Will that work for this printer or does it install its own driver when plugged in? Thx

[bolsoncerrado]

To me Repetier is also better so far... At least u can control the printer from there and even accessing the SD card which Cura does not allow to.

OR may be Rapide can send us a Cura manual to assist us....


PS. You can paste videos (embed) using the video button besides the image button on the editor toolbar. Just paste your youtube URL there.