Cube Pro Trio (hacked) Parts

[hashish]

Hi guys,

I tried searching to see if this is ok to post (sorry mods if I am out of order).

Long time member, but I haven't been very active. I have a Cube Pro Trio that I am trying to part out for a non-profit maker space to build a high temp 3d printer. I have:

- Controller w/ hacked firmware
- Full hotend assembly with circuit boards, fans, extruders, etc.. (sold)
- heater relay
- CB200PS24 power supply & cover
- Enclosure Heater relay board & cover
- LCD screen
- 3x filament cartridge brackets, one chip reader has bent pins but the other two work fine (sold).

I also have a cartridge programmer and a bunch of cartridges that are already hacked, sorry but the jpg's for these won't upload for some reason:
- INF
- Nylon
- ABS
- PLA

I have heatware (if that's still a thing) and an ebay account, which are but full marks. I can send a detailed invoice via paypal so you have buyer protection. Thanks!

20211003_130627.jpg20211003_130726.jpg20211003_130828.jpg20211003_131152.jpg

[bolsoncerrado]

20211003_131152.jpg

Int'd!

[dougk12]

Hi, I'm interested in the printjets and system board (if you have the activation PIN or S/N). Please PM me.

[NitaAlexis]

Looks like a ram stick.
Is it complicated to install?

[hashish]

You mean the control board? No it's not, just a few screws and then all the connectors are JST type connectors.

[Bucketwheel]

Hi, I'm interested in the cartridge programmer and some of your cartridges (INF and Nylon). Is it too late?

[hashish]

Send a PM, thanks.

[cbeyer5420]

Hey there, do you still have any of these item left?

[TommyDee]

You might try sending the OP a message.

[hashish]

Sorry all items have been sold, can you close the thread. Thanks!