How to Extend life of your Printing Filaments...

[bolsoncerrado]

You may not be aware, but humidity may ruin your 3d prints over time...just like this:

TO avoid the above, specially if you've bought multiple colors but dont plan to spend them all at once or in the near future, do yourself a favour:

1- Grab one of the multiple food sealers available anywhere
2- Optional: get additional food sealer rolls if you plan to seal many spools.
3- Bag one spool per roll bag or leave enough roll space to reuse it a few times and leave it like this:

Enjoy everlasting printing fun!

[bolsoncerrado]

And now the DIY solution:

[Holgamods]

Seems everyone liked my idea for food sealers....

[Susanne]

Thanks for sharing this video.

It depends on the filament you are using. In fact there is a whole range of variations here, ranging from water absorption to becoming brittle.

[TommyDee]

Just use up the filament before it goes bad