Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2
  1. #1
    3D Printer Noob
    Join Date
    Jan 2022
    Post Thanks / Like

    Help: Finding Cause of Warped Output

    Longer LK4 Pro (
    Fusion360 and Cura v4.11

    Each time I print the object below--70 x 32 x 8mm block with a few channels--the thing comes out warped as shown in the images. I've generated plenty of objects with this printer, and I've never experienced this problem before.


    I lowered/raised printer's plate temp; I increased/decreased Quality/Infill settings in Cura; I moved the print location on the plate--same result every time. I'm stumped.

    This is the extent of my troubleshooting knowledge, and now I reach out out for suggestions leading to a solution.

  2. #2
    Super Moderator
    Join Date
    Nov 2016
    Post Thanks / Like
    Too hot. PLA likes around 80 degrees in the room and no heating of the bed. Make sure the nozzle isn't radiating excess heat at the print.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts