Thanks Thanks:  0
Likes Likes:  1
Dislikes Dislikes:  0
Results 1 to 10 of 67

Threaded View

  1. #11
    3D Printer Noob
    Join Date
    Oct 2015
    Posts
    1
    Post Thanks / Like
    It is looking that the problem is the board is not self powered standalone.
    According to me the logic side either requires USB or the standard 2.1mm round coaxial power jack 5V.
    There are 2 through holes on the board labeled ground and 5V. That pair is directly in parallel with the round 5V logic input.
    Pretty sure they used the standard USB power switch setup to prevent backfeeding up USB.
    Last edited by UriValle; 10-26-2015 at 05:09 PM.

 

 

Similar Threads

  1. Cube3 main board pics and size please?
    By bolsoncerrado in forum Cube3
    Replies: 7
    Last Post: 06-06-2020, 02:29 PM
  2. Fastbot BBP 1S Board with Octoprint on linux unicorn
    By scottyblue77 in forum Rapide Lite 3D Printers
    Replies: 14
    Last Post: 03-21-2018, 11:50 AM
  3. Raspberry Pi OFFICIAL Touchscreen Display UNBOXING Pics
    By bolsoncerrado in forum Rapide Pi
    Replies: 0
    Last Post: 06-23-2016, 03:22 PM
  4. Replicape – A smart and quiet 3D printer control board
    By bolsoncerrado in forum 3D Hardware
    Replies: 4
    Last Post: 10-28-2015, 07:55 PM
  5. Alligator 32Bit Printer Board Reduced to €120 on Indiegogo
    By BobenhamHotspur in forum 3D Hardware
    Replies: 4
    Last Post: 04-21-2015, 10:45 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •