Just picked up a second CubePro

[Cubical]

Bought it off ebay for <$500. It's a little scratched on the outside, as if it had been in a storeroom getting moved around and stuff stacked on it. But inside it's like brand new, not a single scratch on the build plate. Came with 3 full cartridges too....which to me are valuable mainly for the chip. It has v2.02 firmware but from what I gather from reading here, that shouldn't pose any problem since I recharge the chips.

[TommyDee]

Nice find. Yes, ReCube can regenerate your cartridge. http://www.print3dforum.com/showthre...muro-s-Circuit

[theodoreevans]

This information is just exciting and new. I've been trying to decide where to go to school, and this has helped me in one way