Successful Prints

[sukhvir]

Hi Karthik,

Why have you added the ribs? Are they part of the final print, or are they supports to help the print?

[karthik.pdy]

Hi Sukhvir

I added that ribs as supports and a base with CW.


Sent from my iPhone using Tapatalk

[sukhvir]

A few points to note here Karthik:

- Your supports are too thick. They will damage the part when you remove them.
- This part only needs support on the securing flaps. The base should be sitting directly on the build plate at no angle.
- Add a single layered rim around the whole part which will stop it from lifting at the corners.
- Your supports should be placed closer together (2mm apart rather than 6mm) and should be 0.4 - 0.6mm thick to make them easy to remove.

I'm not sure which CAD package you used to make the part, but I'll see if I can add the supports to your STL file.

[karthik.pdy]

Thanks for your information Sukhvir.

Can you show a picture of single layered rim around the part for my better understanding


Sent from my iPhone using Tapatalk

[karthik.pdy]

Hi sukhvir

can you suggest for this part too... it will be very helpful
https://www.dropbox.com/s/438czedf5i...ttom.STEP?dl=0

[karthik.pdy]

Hi, any one try Materialise Magics software for support generation ?

[bolsoncerrado]

any link, please?

[sukhvir]

any link, please?

http://www.materialise.com/en/software/magics

I think you can download a demo, however full version is for professional level printers (those costing £30k+) and software costs around $20k

[vladimir]

IMG_6856.jpgMadeSolid 50 micron Burn-in Layers

Cure Time 60sec
Normal Layers

Cure Time 30
Morpheus E7

[MadOff]

@vladimir, wich resin ?
magnific result !