Morpheus Modifications

[acnow]

Thanks for the link... it is one I have seen before but have you ran a KS campaign, or are you about to run one? DM me and we can chat further about this.

Have you been having problems with your Morpheus, or have you been getting good prints without any mods? I would love to see the prints you have made with your 3DM resin. Regarding the laser pen, I bought mine on eBay. Just search for a 405nm 5mW UV laser pen. This is the one I bought http://www.ebay.co.uk/itm/3115312855...%3AMEBIDX%3AIT

I just emailed you at the "hello" email that appears on your website and answered your questions there. Thanks for the link about the uv pen!

[woale]

Euhm guys, am I missing something? What kickstarter are you to run @sukhvir?

[sukhvir]

@woale... My friend and I have made a computer to teach kids programming and electronics. It's something we have been working on for a few years now and are about to launch a Kickstarter campaign. It's launching hopefully end of this month but I'll keep you posted but would appreciate any help getting the word out when launched You can find out more info on http://www.thisisada.com

We needed to prototype a few parts as the FDM parts weren't looking too good and required a lot of finishing. the Morpheus prints are looking good though and I'll keep looking for tweaks to perfect the prints.

Has anyone carried out any of the mods I mentioned and had any better luck with their prints?

[woale]

@sukhvir, best of luck with the campaign. It's looking promising.

As for the mods, I've also removed the metal plate from the LCD screen which seem to give more consistent prints. Base layers are sticking better to the build plate, even without using a laser pen.

[sukhvir]

Any chance of sharing your successful prints with us @woale? Would help to boost the confidence of the community.

[woale]

Any chance of sharing your successful prints with us @woale? Would help to boost the confidence of the community.

Too bad I haven't got the time to print anything fancy yet since "upgrade" with your mods.... just the endstops in post #6 above

[acnow]

Too bad I haven't got the time to print anything fancy yet since "upgrade" with your mods.... just the endstops in post #6 above

@woale -just bought the sensors! I wonder where did you purchase the cables you used to connect them with the printer -any link? Thanks in advance!

[woale]

@woale -just bought the sensors! I wonder where did you purchase the cables you used to connect them with the printer -any link? Thanks in advance!

Like these: https://www.sparkfun.com/products/10363 standard 3pin wire, but maybe try to find something a bit longer.
Also an 220 Ohm resistor needs to be soldered on the sensor board, like one of these: https://www.sparkfun.com/products/10969

[acnow]

Like these: https://www.sparkfun.com/products/10363 standard 3pin wire, but maybe try to find something a bit longer.
Also an 220 Ohm resistor needs to be soldered on the sensor board, like one of these: https://www.sparkfun.com/products/10969

Thanks for those useful links @woale. If I buy this one with length 12 .. will it work there? https://www.sparkfun.com/products/10373

[woale]

Maybe look for a longer one. I remember 25cm was too tight, so I used 75cm I had laying around.