Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 4 of 4
  1. #1
    3D Printer Noob
    Join Date
    May 2016
    Posts
    1
    Post Thanks / Like

    Question dumb question, how to distinguish which side of the film is facing upward?

    I am having a hard time using FTD to print,
    it just dont stick to the plate, with lots of failure.
    I am trying to replace the film but I forgot which side should be facing upward.
    And is there any tips on getting the print to stick to the plate ?

    Thanks.

  2. #2
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    3,332
    Post Thanks / Like
    Take a postit and try to glue it on the film, if it sticks well, then you're good to go. if it wont stick, wrong face, try again.

  3. #3
    3D Printer Noob
    Join Date
    Aug 2022
    Posts
    3
    Post Thanks / Like
    By bolsoncerrado in forum Morpheus 3D Printers



  4. #4
    3D Printer Noob
    Join Date
    Sep 2022
    Posts
    6
    Post Thanks / Like
    thanks for sharing

 

 

Similar Threads

  1. Quick dumb question!
    By bolsoncerrado in forum Morpheus 3D Printers
    Replies: 7
    Last Post: 03-02-2016, 04:33 PM
  2. QUICK QUESTION! (I hope!) Do any of your printer (inside case) fans speed up?
    By bolsoncerrado in forum Rapide Lite 3D Printers
    Replies: 17
    Last Post: 03-01-2015, 02:38 PM
  3. Now for the f&(()/·&*!"( question of the month!
    By bolsoncerrado in forum Rapide Lite 3D Printers
    Replies: 2
    Last Post: 02-26-2015, 07:53 AM
  4. Heat bed question
    By Skinny Kid in forum Rapide Lite 3D Printers
    Replies: 2
    Last Post: 01-27-2015, 09:54 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •