Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2
  1. #1
    3D Printer Noob
    Join Date
    May 2016
    Posts
    1
    Post Thanks / Like

    Question dumb question, how to distinguish which side of the film is facing upward?

    I am having a hard time using FTD to print,
    it just dont stick to the plate, with lots of failure.
    I am trying to replace the film but I forgot which side should be facing upward.
    And is there any tips on getting the print to stick to the plate ?

    Thanks.

  2. #2
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    2,999
    Post Thanks / Like
    Take a postit and try to glue it on the film, if it sticks well, then you're good to go. if it wont stick, wrong face, try again.

 

 

Similar Threads

  1. Quick dumb question!
    By bolsoncerrado in forum Morpheus 3D Printers
    Replies: 7
    Last Post: 03-02-2016, 04:33 PM
  2. QUICK QUESTION! (I hope!) Do any of your printer (inside case) fans speed up?
    By bolsoncerrado in forum Rapide Lite 3D Printers
    Replies: 17
    Last Post: 03-01-2015, 02:38 PM
  3. Now for the f&(()/&*!"( question of the month!
    By bolsoncerrado in forum Rapide Lite 3D Printers
    Replies: 2
    Last Post: 02-26-2015, 07:53 AM
  4. Heat bed question
    By Skinny Kid in forum Rapide Lite 3D Printers
    Replies: 2
    Last Post: 01-27-2015, 09:54 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •