Thanks Thanks:  4
Likes Likes:  1
Dislikes Dislikes:  0
Page 4 of 4 FirstFirst ... 234
Results 31 to 32 of 32

Thread: Hardware Share

  1. #31
    3D Printer Noob
    Join Date
    May 2017
    Post Thanks / Like
    Sorry if i'm wrong room, but anyone know cube3 belt spec? thanks

  2. #32
    3D Printer God(dess)
    Join Date
    Nov 2016
    Post Thanks / Like
    It is a good room for that. Good question. Typically you just measure the width of the belt and the pitch. That will get you to the right ballpark. Most belt and gear manufacturers will have a series of belts with the same pitch depending on robustness. You can pretty much bet 3DS went for the cheapest.

    Normally these belts are littered with markings. It only has a part number somewhere if I recall. These were custom cut to length for 3DS, I'm sure.



Similar Threads

  1. Share your Polygon Build
    By nunyafb in forum Polygon Delta Printers
    Replies: 2
    Last Post: 09-02-2016, 07:49 AM
  2. Hardware Spare Parts
    By Zoom in forum Rapide Lite 3D Printers
    Replies: 62
    Last Post: 09-11-2015, 12:32 AM
  3. Just wanted to share....
    By bolsoncerrado in forum 3D Print Materials & Filaments
    Replies: 0
    Last Post: 06-02-2015, 02:48 PM
  4. 11 Experts Share Their Top 3D Printing Beginner Tips
    By bolsoncerrado in forum Latest News
    Replies: 0
    Last Post: 05-11-2015, 10:59 AM
  5. [HOW TO] Set up the Hardware
    By JonatanJacobsson in forum Rapide Lite 3D Printers
    Replies: 25
    Last Post: 01-23-2015, 04:06 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts