Use other slicers with cube 3

[Mythandar]

http://3dcreatorhub.com/viewtopic.php?f=6&t=26

[bolsoncerrado]

Thanks for sharing! Gonna try asap!

[MegaloDon]

I wanted to try this with Kisslicer but there are a crapload of settings that I have no idea what to set them for the Cube 3. Can you tell me what settings to set for Cube 3?

[Mythandar]

I did get some decent prints out of kisslicer as well. However, it doesn't do retraction properly for what a cube 3 needs.

Heres a link to my ini files for kisslicer. https://1drv.ms/u/s!AtMbZIO7-msPgq1XWYUkn8s6rpwgOw

Just find your kisslicer directory and if you don't care about any of your current saved profiles then copy these over the ones you have there . If you don't want to lose your profiles you already have then just open each file in a text editor and copy everything inside and paste it at the end of your ini file of the same name.

[MegaloDon]

Heres a link to my ini files for kisslicer. https://1drv.ms/u/s!AtMbZIO7-msPgq1PLqht61Fh46yEQQ

Awesome! Thank you very much! I'm gonna try it after work.

[Ariel5227]

Hello!! can you send me this ini files please!! Thank you!!

[Mythandar]

I think I have my simplify3d settings where it does a pretty good print. I'm going to post a few comparison pictures tomorrow that compare against the cube print slicer.

[bolsoncerrado]

Well so far I opened a STL and sliced with the above profile and when I run the preview, it's empty! :?

Is this normal?

Item is manifold.

[Mythandar]

Well so far I opened a STL and sliced with the above profile and when I run the preview, it's empty! :?

Is this normal?

Item is manifold.

So when you hit "prepare to print" and it goes to the preview it doesn't show anything? If that's the case then I don't think a profile affects that. Make sure build table, travel moves, and toolhead are selected in the preview screen.

[MegaloDon]

Not sure if I missed something but it is backing the filament out instead of feeding it. Also does it only work on the left side? Is there a way to select which side?