Thanks Thanks:  8
Likes Likes:  10
Dislikes Dislikes:  0
Page 12 of 12 FirstFirst ... 2101112
Results 111 to 112 of 112

Thread: Filament Review

  1. #111
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    2,905
    Post Thanks / Like
    Wow looks gorgeous

  2. #112
    3D Printer God(dess)
    Join Date
    Nov 2016
    Posts
    1,028
    Post Thanks / Like
    The previous pen-pack filament assortment was donated to a "pen-pal" save the one non-glowing GITD orange.
    So I ordered more from Amazon.
    This time 25ft lengths x 20 each multicolor for ~$10/USD.
    These were marked 160*c at the low end.

    Seems all this stuff comes from the same mill.
    Beautiful test print! ...again.
    And a nice hold on plain Lokbuild as well.

    So if you are buying filament just to have a little of many colors, I highly recommend these pen-packs.
    No need to push a particular ad; just give any pack a try.
    So far, this is more consistent than a shot in the dark with "engineered" filament, only to have to send it back.

    In case you are wondering, 25ft of filament will print approximately 2 hours in the Cube 3.
    Made a test print, the 3DS rook, and 6ft remaining.
    And the red is the red I've been looking for in other suppliers; opaque, vivid, consistent.

    The only con so far is that it this material strings more than some. A flameless butane device works wonders on strings.

    additional update: The glow-in-the-dark pen filament is a little harder than the non-GITD.
    A little more work to feed but it is still printing beautifully. Thought I'd add that.
    Last edited by TommyDee; 11-11-2017 at 08:04 AM.

 

 

Similar Threads

  1. Mark IV Review
    By AngryPanda in forum Morpheus 3D Printers
    Replies: 128
    Last Post: 11-06-2017, 09:59 AM
  2. The Palette - Unboxing (and coming soon: the Review)
    By bolsoncerrado in forum The Palette
    Replies: 3
    Last Post: 07-28-2017, 10:42 AM
  3. The (PRINT3Dforum) Morpheus 3D Printer Review! (WIP)
    By bolsoncerrado in forum Morpheus 3D Printers
    Replies: 0
    Last Post: 02-29-2016, 09:26 PM
  4. REVIEW: Rapide Lite 200 + AstroPrint = Successful print!
    By bolsoncerrado in forum Rapide Lite 3D Printers
    Replies: 7
    Last Post: 01-22-2015, 02:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •