Thanks Thanks:  8
Likes Likes:  13
Dislikes Dislikes:  0
Page 13 of 13 FirstFirst ... 3111213
Results 121 to 122 of 122

Thread: Filament Review

  1. #121
    3D Printer God(dess)
    Join Date
    Nov 2016
    Post Thanks / Like
    I see and understand. I'd love to have a handle on all the basic feed systems in the BFB. A simple reduce motion speed (%); reduce feed speed(%); and increase temperature (%) would go a long way to managing harder filaments. The eSun filament I used was great, except it was brittle and skipped a lot in the drivers. So a little less pressure and a little more flow from higher temperatures and slowing the table should result in some better fill properties.

  2. #122
    3D Printer Noob
    Join Date
    Dec 2017
    Post Thanks / Like
    Liking the MG Chemicals Wood Filament. This was my first attempt at staining it and thought it came out pretty well. I'm using kisslicer and still dialing in settings, but it prints using my standard pla settings. My next project is a 3D Terrain Puzzle using this filament.

  3. Likes TommyDee, bolsoncerrado liked this post


Similar Threads

  1. Mark IV Review
    By AngryPanda in forum Morpheus 3D Printers
    Replies: 128
    Last Post: 11-06-2017, 09:59 AM
  2. The Palette - Unboxing (and coming soon: the Review)
    By bolsoncerrado in forum The Palette
    Replies: 3
    Last Post: 07-28-2017, 10:42 AM
  3. The (PRINT3Dforum) Morpheus 3D Printer Review! (WIP)
    By bolsoncerrado in forum Morpheus 3D Printers
    Replies: 0
    Last Post: 02-29-2016, 09:26 PM
  4. REVIEW: Rapide Lite 200 + AstroPrint = Successful print!
    By bolsoncerrado in forum Rapide Lite 3D Printers
    Replies: 7
    Last Post: 01-22-2015, 02:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts