Thanks Thanks:  9
Likes Likes:  19
Dislikes Dislikes:  0
Page 14 of 14 FirstFirst ... 4121314
Results 131 to 133 of 133
  1. #131
    Expert 3D Printer
    Join Date
    Jan 2017
    Posts
    466
    Post Thanks / Like
    So I tried printing Taulman Bridge nylon on my Cube 3 and it works quite well. I didn't even need to use a 3rd party slicer. Just used Cube Print software and set it to ABS. Taulman Bridge prints around 250 and Cube Print software prints ABS at 260. Only slight stringing. The print could have been better but I had moisture in the filament. (This stuff picks up moisture like crazy compared to other filaments.) A lot of popping and cracking during print, but overall came out pretty good.

    Clip.JPG

    Clip2.JPG

  2. Thanks dthomas6184 thanked for this post
    Likes bolsoncerrado, dthomas6184 liked this post
  3. #132
    Administrator bolsoncerrado's Avatar
    Join Date
    Nov 2014
    Posts
    2,968
    Post Thanks / Like
    Great to know, definetly!!

  4. #133
    3D Printer God(dess)
    Join Date
    Nov 2016
    Posts
    1,133
    Post Thanks / Like
    How much lower can they go (?)

    I wasn't going to do it. I was going to be more than satisfied with 3 printers... and I got a 4th.
    Then I was going to be satisfied with 4 printers... and now this

    Who can turn down a deal on a new printer with 2 spare new cartridges for $125! + a few $ in octane.

    I couldn't either. Shipping normally kills the deal.

    All registered and ready to roll. Wait... reload FW!

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •