Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11
    3D Printer Noob
    Join Date
    Apr 2017
    Posts
    5
    Post Thanks / Like
    Quote Originally Posted by MegaloDon View Post
    I had problems where it sometimes wouldn't read my USB stick. I started using an extension cable because it was easier than reaching down there and couldn't see the port very well. It turns out that the connections on both ends of the extension cable are a tighter fit and I haven't had that problem since.

    However, as Tom pointed out, you had the same problem with wifi. So it is unlikely that that is the problem.

    Hmm... Could the problem be within the printer's system then?

  2. #12
    Super Moderator
    Join Date
    Nov 2016
    Posts
    3,392
    Post Thanks / Like
    Any firmware operation is risky.
    There are no official trouble shooting guides.

    ...however
    We've gotten inside; we know what we're looking at; and we can operate the Cube while having access to the SD drive.
    Any disruption in the SD prompts a firmware installation.

    One problem that is real easy to fall for is the end of the FW update...
    It just kind of turns off and eventually comes back.
    Here, you will need patience.

    Again, DON'T LOOSE THE 2 .BIN FILES!

 

 

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •