Search:

Tag: rapide lite

Search: Search took 0.00 seconds.

  1. OctoPrint/OctoPi Profile for Rapide Lite 200

    Started by Rep3D, 07-04-2015 06:15 PM
    octoprint, profile, rapide lite
    • Replies: 3
    • Views: 9,944
    Last Post: 07-06-2015 01:28 PM
    by bolsoncerrado  Go to last post

    Forum:
    Rapide Pi

  2. Heat Bed Not Recognized?

    Started by turnearner, 04-09-2015 12:00 AM
    enabled, heat bed, rapide lite, repetier, rumba
    • Replies: 4
    • Views: 7,037
    Last Post: 04-10-2015 12:54 AM
    by Holgamods  Go to last post
  3. Board Swapping

    Started by ph03nix, 02-13-2015 02:00 PM
    5 Pages
    1 2 3 ... 5
    • Replies: 42
    • Views: 35,272
    Last Post: 02-24-2015 11:30 AM
    by ph03nix  Go to last post
  4. Rapide Lite 200 print layers are not aligned

    Started by rishabhtulsian, 02-01-2015 06:30 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 11,840
    Last Post: 02-04-2015 01:37 PM
    by BobenhamHotspur  Go to last post
  5. Rapide Lite 200 under Linux

    Started by robml, 12-23-2014 04:31 PM
    3d printer, linux, rapide lite
    • Replies: 4
    • Views: 7,068
    Last Post: 01-14-2015 08:07 PM
    by BobenhamHotspur  Go to last post
Results 1 to 5 of 5